With the left blade guard fitted…to safeguard fingers we can move onto making the lower blade guides.
First thing is to remove the table.
I need some more 608 bearings so earlier in the week bought another skateboard from Kmart.
I need one set from one end of the board.
Bugger…they are the flange type, I’ll take it back and exchange for another one of different brand. It’s a lucky dip, I want the plain type of bearing.
Mocking up with clamps, the left pine block screwed in as is, the right will slide front to back.
I need to notch out the table support.
One of my favourite hand tool is this panel saw.
With that cut out the guide block can slide for bearing guide alignment.
More to come…
No comments:
Post a Comment