DJ TV Display - Part 1

Doing a job for Philip Tyme to make a integrated display TV unit for DJ gigs.

For the Bunnings plywood we both had to ring around, see the picture further down the page.

Nothing out his way and in my side the only one was Notting Hill so off yesterday morning in the Camry to buy 3 x 1200 x 600 x 18mm @ $35 per sheet. Loaded nicely across the back seat. We are using this picture that Philip found on the net.

We are using 3 sheets of 18mm so each side will be 58mm wide.

Three sheets cut in half for six panels so three per side.

The 58" TV needs to angle back a bit so we mesured, marked and cut the bottom of each panel on the 12" mitre saw for a angle of about 15 degrees.

More to come...