DJ TV Display - Part 3

Completed the second side, that is the right side in 1/3 the time it took to do the first side - the left side.

Ready for the next stage of the build each side will have four large holes.

Don't want to duplicate to much so for the previous session I took photos every so often.

For this session we'll take in between photos - something like that.

AA

After marking out the drill locations we just clamped up to drill the pilot holes.

Drill pilot and shank clearance holes followed by countersinking.

With the Torx screws in we can move onto rounding the top corners.

Using the special templates; cat food tin and cover from danish butter cookies tin, we trace out this top panel.

Unscrew the panels and mark out the other two. We can then start cutting.

With jigsaw cutting done screw the three panels together again and prep for smoothing off with rasp and orbital sander.