Before continuing with the sliding sled box I noticed that the MDF sanding disc had wheel to much wheel wobble so corrected that while it's in my mind.
One side of the 30cm disc was not completely flush with the backing plate. This what happens when you didn't use clamps while putting in the screws.
Making the sled box.
The sled box is done so we can now mount that onto the sliding sled base.
Once again using clamps aligned everything and put in two screws, then drilled the pilots and countersunk the rest.
For the next session prepping to make the sled block clamp.
Drilled the 3/8'' bolt hole.
That's enough for now...back soon.
No comments:
Post a Comment