Took a bit of edge sanding to get it sliding nicely and if needed I use talcum powder.
Doing some test cutting.
Monday, April 27, 2015
Bandsaw 40 - New table
Further to this just finished routing a 12mm mitre track down the table for cross cuts. Next job is to do one across for rip cuts. Oldies reading this should note the make of the (all metal) mitre gauge!
Took a bit of edge sanding to get it sliding nicely and if needed I use talcum powder.
Took a bit of edge sanding to get it sliding nicely and if needed I use talcum powder.
Subscribe to:
Post Comments (Atom)
Medion Wireless Rear View Mirror - Revisited
Purchased this from ALDI in August 2015 and earlier this year it stopped working. I have been dealing all year with the left eyeball and poo...
-
SK5 steel, non stick coated cutting blade Includes saw attachment Telescopic aluminium pole Ideal for sawing or lopping hard to reach p... -
Suitable for use in the chook run where there is 240V power for the 12V power supply or powered from 12V SLA battery (also solar panel) for ...
No comments:
Post a Comment