Refurbishing BBQ table - Part 2

 Screwed on that last board at the back of the table and braced the legs.

With the last board screwed down there's bit of bracing sticking out; that was planned because I'll run some timber along the back to stop stuff falling of the back edge of the table.

With the table turned over flat on the ground braced both the legs.

Some odd angles here so I roughly marked out with a Texta and went in the workshop to cut the funny angles.

Mitre saw to cut the 45's.

Homemade 14" bandsaw to cut the weird angles.

With that done went out and screwed the braces onto the legs.

Much more stable now.

Back tomorrow...