Charlie along with other partners in damage, attempting to get to the covered feed tray, hacked away at the feed cover until it was ripped away from the servo actuator arm and ended up on the lawn.
Yep... it's back in the workshop!
It will sit between the platform and the feed cover... something like that.
Note how the feed cover has been hacked around the circumference - lol
It will sit between the platform and the feed cover... something like that.
Note how the feed cover has been hacked around the circumference - lol
The main mounting base has been lifting away from the platform because the screws I used are to small.
Cleaned it up and selected larger screws.
With that done we can move onto the feed tray guard, the large pot plant saucer.
It will sit on this corner.
The rim on the right half will be cut out to allow the feed cover to swing into position.
With one half of the rim cut out we now need to make sure it's centered below the feed guard cover and then screw down.
Had to remove everything to cut a recess on the 8" band saw to cater for the angle of the pot plant saucer.
With that correctly located and screwed down time to take a break.
No comments:
Post a Comment