Every couple of years we get a new turbo brush for the Nilfisk Bravo vacuum. This time Godfreys – Knox only had the display one so got it for $69.95. On a monthly basis I pull it completely apart and clean/service but even with all that TLC the plastic end bearings inevitably wear/overheat/distort. I'm working on a fix for this, intending to replace the eight skate board blade guide bearings on my homemade band saw with UHMW plastic from Carbatec and I'll use the leftover to make end bearings for the turbo brush.
Subscribe to:
Post Comments (Atom)
-
With the Wi-Fi Valve setup and operating we can start making the door frame and the actual door that will slide up and down inside a frame. ... -
Suitable for use in the chook run where there is 240V power for the 12V power supply or powered from 12V SLA battery (also solar panel) for ...
No comments:
Post a Comment