Replacing the electronics/electrical workbench top storage shelf which was simply a length of fence paling timber.
Removed everything that was stored on the narrow flooring board.
This is what started this project, I came across a nice length of laminated chipboard.
Setting up the Ozito 12" mitre saw.
The board is long enough so there will be enough for the two end supports.
With that done we can start screwing it together.
That's the right side where the end support simply butts up to the edge or the shelf.
Pre-drilling and countersinking the four screws holes.
Ensure everything is square and..
clamped.
We are using ALDI WorkZone screws.
Torx head wood screws.
Find the right bit size.
With top and bottom clamped drive in the two middle screws, then remove clamps and do the other two.
Now we need to measure and mark the location for the other end support.
Back soon...
No comments:
Post a Comment