Thursday, April 25, 2019

Samoyed night light - part 5

Mounting the controller behind the base board.

Measure the width.
Measure and mark the location for the sensor or PIR on the bottom edge of the frame.


OK…let's bore the hole.






















Using a 15mm Forstner bit. Fingers crossed we haven’t stuffed up.

OK…now turn it over.

That's good...the camera angle gives the impression the PIR is off centre.


at
Labels: , , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Another new toy for kitties.

 

  • Wi-Fi Chicken Door - Part 3
    With the Wi-Fi Valve setup and operating we can start making the door frame and the actual door that will slide up and down inside a frame. ...
  • Wi-Fi Chicken Feeder - Part 1
    Suitable for use in the chook run where there is 240V power for the 12V power supply or powered from 12V SLA battery (also solar panel) for ...
  • ALDI – Sewing Table
    The sewing table is HEAVY…about 40kg