Base board frame glue-up is done.
Cutting some stand-offs for the back of the subject, in this case a Samoyed.
While doing this I'm thinking about how to mount the LED strip controller on the back of the base board?
Subscribe to:
Post Comments (Atom)
-
With the Wi-Fi Valve setup and operating we can start making the door frame and the actual door that will slide up and down inside a frame. ... -
Suitable for use in the chook run where there is 240V power for the 12V power supply or powered from 12V SLA battery (also solar panel) for ...
No comments:
Post a Comment